Alientech KESS3 Flat Cable 144300T105

• A 16‑wire flat (rainbow) ribbon cable with an IDC26 connector at one end and a 16‑pin termination.

• Designed to be used with the KESS3 tool for bench mode and bootloader connections directly to an ECU’s circuit board.

 Typical use:

• Connects your KESS3 programmer to a vehicle’s ECU when you’re performing direct board‑level reads/writes (bench or boot mode) rather than via the OBD port.

• Useful for professional ECU tuning, repairs, or cloning where direct access is required.