BitBox Ford Delphi / Visteon Diesel CAN

• It’s not a physical device, but a software activation/module you add to the BitBox system (requires a BitBox dongle + software).

• This specific module is for reading and writing (flashing) ECU firmware and calibration data over the vehicle’s CAN bus on certain Ford diesel vehicles equipped with Delphi or Visteon engine control units (ECUs).

Delphi DCM3.5
‑ Based on the MPC5566 microcontroller.
‑ You can read/send calibration data and rewrite the ECU’s flash over CAN.

2. Delphi DCM6.1
‑ Based on the Infineon TC1797 chip.
‑ Same CAN read/write and checksum support.

3. Visteon DCU‑10x / DCU‑20x
‑ Based on ST10F276 microcontrollers.
‑ Also supports read/write with checksum correction via CAN.